ZL18 car aluminum alloy wheel hub shot blasting machine
Electricity key parts:
Siemens, Omron, Schneider, Mitsubishi
contribute to painting and coating.:
Remove rust and corrosion
Abrasive reclaim system:
3 classes full flow curtain hammer style
Electrical control system:
Auto-detection, auto-alarm and auto-cutout.
Setup safety interlock device between systems
pulse-jet cleaning bag filter to remove dust
After-sales Service Provided:
Engineers available to service machinery overseas
200 Set/Sets per Year or more for shot blasting machine
Packaging & Delivery
car aluminum alloy wheel hub shot blasting machine
wrapped by plastic, then into MDF wooden carton, so avoid rust during shipping.
New ZL18 q376 aluminum alloy rim hook type wheel hub shot blasting machine
Hook type shot blasting machine includes: Q372 hook type shot blasting machine & Q374 hook type shot blasting machine. Hook type shot blasting machine A new type of cleaning equipment for surface cleaning and strengthening of castings, forgings and round springs and bearings. It can clean the workpiece's weight, size, volume, production efficiency, and can be manually, mechanically or automatically fed. The workpiece is tumbling in a blasting chamber consisting of an annular grooved belt and two heads made of highly wear-resistant material. The conveyor belt is provided with guide strips to ensure that all surfaces of the workpiece are exposed and turned over. There will be no excessive collisions.
The shot blasting machine is suitable for multi-variety, large- and medium-volume production of workpiece surface rust or shot peening, cleaning workpiece must be not afraid of collision of single weight less than 150kg castings and heat treatment parts, the machine can be used alone or with Line use. Belongs to the scope of casting machinery.
If you have any question or concerns, pls feel free to contact us.
1,What is the target market for this machine?
The Blaster is designed for customers who require a more sophisticated method than just manual cleaning in preparation for further processing or painting.
2,What type of abrasive media does it use?
The Blaster is designed to use round steel shot. The shot is recycled inside the system and gets smaller and smaller during the blasting process, until it is completely consumed. Approximately two tons are required for start-up, and approximately 20 pounds are consumed per blasting hour. Replenishment is easily done as needed.
3,What utilities are needed to run the Blaster?
The electrical system runs on three-phase input and a transformer will be provided for your supply voltage if required. Clean and dry compressed air supply is also needed.
4,What does it cost to operate?
The highly efficient turbines require much less power that competitor's shot blast machines. Including abrasive consumption, power consumption and maintenance, the total operating cost averages around $20 per hour in US. When comparing this to your current methods, keep in mind that the Blaster is at least 4 to 5 times as productive as manual cleaning and only one operator is required to load and run the machine while it is working. Labor costs are much lower, plus you will have a huge amount of extra capacity for cleaning.
5,Are there any special operator skills required for the Shot Blaster?
No, once the machine is installed and adjusted by our technician, running the machine consists of merely switching it on and setting the speed dial for the desired surface finish. Maintenance is simple too.